[ March 24, 2005 - CMS GT-27 / Fagor 8025-T - written by JP
[ This program for the GT-27 lathe turns down 7/8" Aluminum
[ round bar to .685" on one end, .745" on the opposite end,
[ then parts off at .875" length. 
[ Transmission plug for Bob Carpenter / TransKing Inc.
[ >>>>>>>>>>>> Set ZERO point at end of material <<<<<<<<<<<<
%00030
N010 G40 G70 G90 (Comp Cancel, Inch, Absolute)
N020 G95 F0.006 (Inches Per Rev Feed)
N030 G97 S1000 M03 (Speed 1000 RPM, CCW)
N040 T06.06
N050 G00 Z1.000 M08 (Move Z+ to change tools, Coolant On)
N060 T01.01 (Left A tool)
N070 G00 X-0.840
N080 G00 Z0.050
N090 G01 Z-0.885 (First turn)
N100 G00 X-0.835
N110 G01 Z0.050
N120 G00 X-0.775
N130 G01 Z-0.530
N140 G00 X-0.780
N150 G00 Z0.050
N160 G00 X-0.700
N170 G01 Z-0.530
N180 G00 X-0.880
N190 G00 Z-0.5315
N200 G01 X-0.6855
N210 G01 Z0.050
N220 T02.02 (Right A tool)
N230 G00 X0.900
N240 G00 Z-0.885
N250 G01 X0.780 
N260 G01 Z-0.690
N270 G00 X0.810
N280 G00 Z-0.880
N290 G01 X0.750
N300 G01 Z-0.690
N310 G00 X0.850
N320 G00 Z-0.6885
N330 G01 X0.7445
N340 G01 Z-0.880
N350 G00 X0.850
N360 G00 Z2.000 (Move Z+ to change tools)
N370 T05.05 (Parting tool)
N380 G00 X-0.900
N390 G00 Z-0.875
N400 G01 X0.000 F0.001
N410 G00 Z0.040 M09 (Coolant Off)
N420 G00 Z1.000
N430 T06.06 (Use Tool 1 for Stop)
N440 X0.000
N450 Z0.000
N460 M05 (Spindle Stop)
N470 M30 (Program End, Reset)