[ This program for the GT-27 lathe turns down 7/8"
[ brass round bar to .772" then turns down the
[ center area for a bullet used to clean out tubes.
[ Remove these comments prior to sending the
[ file, or be aware that file x-fer may fail!
[ - - Set ZERO point at end of material - -
%00010
N010 G40 G70 G90 (Comp Cancel, Inch, Absolute)
N020 G95 F0.010 (Inches Per Revolution)
N030 G97 S0800 M03 (Speed 750 RPM, CCW)
N040 T1.1
N050 G00 Z1.000
N060 G00 X0.785
N070 G00 Z0.050
N080 G01 Z-0.800
N090 G00 X0.800
N100 G00 Z0.050
N110 G01 X0.772
N120 G01 Z-0.800
N130 G00 X0.800
N140 G00 Z-0.288
N150 G01 X0.685
N160 G01 Z-0.445
N170 G00 X0.800
N180 T2.2
N190 G00 X-1.000
N200 G01 Z-0.906
N210 G01 X0.000 F.001
N220 G00 Z0.040
N230 G00 X2.500
N240 M05 (Spindle Stop)
N250 M30 (Program End, Reset)