[ This program for the GT-27 lathe turns down .564"
[ Delrin round bar to .545", then parts off at .550"
[ Length for a bullet used to clean out tubes.
[ Remove these comments prior to sending the
[ file, or be aware that file x-fer may fail!
[ - - Set ZERO point at end of material - -
%00025
N010 G40 G70 G90 (Comp Cancel, Inch, Absolute)
N020 G95 F0.012 (Inches Per Revolution)
N030 G97 S1000 M03 (Speed 1000 RPM, CCW)
N040 T05.05
N050 G00 X-0.530
N060 G01 Z-0.6125
N070 G01 X0.000
N080 G00 Z0.000
N090 G00 X0.250
N100 M05 (Spindle Stop)
N110 M30 (Program End, Reset)