[ CMS PROGRAM WRITTEN MARCH 22, 2008
[ BY JP SMITH FOR FRESHOUR MANUFACTURING
[ THIS PROGRAM FOR THE GT-27 LATHE TURNS
[ DOWN .625" DELRIN ROUND BAR TO .585",
[ THEN PARTS OFF AT .590" LENGTH FOR A
[ PIG USED TO CLEAN OUT TUBES. REMOVE
[ THESE COMMENTS PRIOR TO SENDING THE
[ FILE, OR THE FILE X-FER MAY FAIL!
[ - .075" TOOL FOR PARTING AND AS STOP
[ - SET ZERO POINT AT END OF MATERIAL -
%00585
N010 G40 G70 G90 (Comp Cancel, Inch, Absolute)
N020 G95 F0.012 (Inches Per Revolution)
N030 G97 M10 (Cancel CSS, Close Collett)
N040 S1600 M03 (Speed 1600 RPM, CCW)
N050 T05.05 (Tool 5, Offset 5)
N060 G00 X -0.585 (Move to X Dia.)
N070 G01 Z -0.590 (Turning @ X Dia.)
N080 G01 X0.050 (Part Off)
N090 G00 X -0.600 (Move Tool Out)
N100 G00 Z0.097 (Position Z)
N110 G00 X0.500 (Position X)
N120 M05 (Spindle Stop)
N130 M11 (Open Collett)
N140 M30 (Program End, Reset)